View Lab Report – E2_Lab_2_8_2_instructor from CSTN WAN at Georgian College. Lab Challenge Static Route Configuration (Instructor Version). View Lab Report – E2_Lab_2_8_2 from ARCHUD 30 at University of California, Los Angeles. Lab Challenge Static Route Configuration Topology. Lab Challenge Static Route. Advanced Static Routing Lab – Router Alley. Lab Configuring Static Routes Ã¢Â€Â“ Instructor Version ·
|Published (Last):||6 December 2008|
|PDF File Size:||8.56 Mb|
|ePub File Size:||9.23 Mb|
|Price:||Free* [*Free Regsitration Required]|
Cable a network that is similar to the one in the Topology Diagram. If challenhe of the above pings failed, check your physical connections and configurations. Verify Connectivity to Next-Hop Device. You have been given the Configure a message-of-the-day banner. Without testing it first, do you think that PC1 can now successfully ping PC2?
What networks are present in the HQ routing table? Configure and Activate Serial and Ethernet Addresses.
Lab Challenge Static Route Configuration (Instructor Version)
Therefore, it is important that you understand the types of errors an ISP could make that would cause your networks to lose conflguration. Document the Router Configurations On each router, capture the following command output to a text.
However, your service provider is an active partner in solving your connectivity needs. Routing challwnge Switching in the Enterprise. Scenario In this lab activity, you will be given a network address that must be subnetted to complete the addressing of the network shown in the Topology Diagram. Record the command to configure a default static route using the appropriate exit interface.
Clean Up Erase the configurations and reload the routers.
Synchronize unsolicited messages and debug output with solicited output and prompts for the console and virtual terminal lines. Configure HQ with a static route. Service provider administrators are human, too, and make mistakes. Configure the Ethernet interfaces. Using the next-hop IP address, configure ISP with a summary static route that includes all of the subnets that are missing from the routing table. In a real-world implementation of this topology, you would not be configuring the ISP router.
Documents Flashcards Grammar checker.
Configure HQ with a default static route. View the routing table of ISP to verify the new static route entry. Examine the network requirements.
Subnet this network to provide enough IP addresses to support 60 hosts. Assign the last valid host configurattion in subnet 1 to PC2. Static Routing Lab 2. You can use any current router in your lab as long as it has the required interfaces as shown in the topology. Perform Basic Router Configurations.
Lab 2.8.2: Challenge Static Route Configuration (Instructor Version)
Answer the following questions to verify that the network is operating as expected: Challenge Sttic Route Configuration Step 2: Configure an EXEC mode password. Assign the last valid host address in subnet 3 to PC1. Page 7 of 7. HQ must be able to send any traffic for which it does not have a route to ISP. What networks are present in the ISP routing table?
Packet Tracer Skills Integration Challenge.
Lab 2.8.2: Challenge Static Route Configuration
Configure ISP with a summary static route. Record the command you used. Clear any existing configurations on the routers. Document the addresses to be used in the table provided under the Topology Diagram. Challenge Static Route Configuration 3.
View the routing table of HQ to verify the new static route entries. From PC2, is it possible to ping PC1? Assign subnetwork addresses to the Topology Diagram. The summary route will also include the subnet zero route that is reserved for future expansion.
Static routes will also need to be configured so that hosts on networks that are not directly connected will be able to communicate with each other. Subnet 0 will be available configuratioon future expansion. This document is Cisco Public Information.