Instruction Manual, Brother XL Details. Brother Model XL Sewing Machine Instruction Manual, Pages. You May Also Like. Foot Control with Cord. Brother XL manuals and user guides for free. Read online or download in PDF without registration. XL – read user manual online or download in PDF format. Pages in total:

Check the needle from the top and the sides. It may become necessary to reship the machine.

Brother XL-6562 Owner’s Manual

When sewing with the twin needle, be sure the Stitch Width X, is not set above 3 since this may cause the needle to hit the needle plate and break. If you’re talking about the bar that goes into the front of the machine and goes up and down, apply some BLUE threadlocker to the screw that holds it in place.

The distance in the scale between two lines of the same length is 0. Abaisser le levier du pied-de-biche. Use a screwdriver to securely. Page 68 – Odd-shaped buttons that do not fit into To change your machine to the free-arm style, simply lift out the flat bed attachment. Change the foot to the Zigzag presser foot. The sewing needle must always be straight and sharp for smooth sewing.

Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the groove of the bobbin. A Locks appear on the surface of the fabric.

The machine will brkther sew forward. When using the twin needle, be sure to use zigzag presser foot only. For a button with a diameter of 1.

Make sure it is thoroughly brushed and cleaned out. Tell us about it. Ask a Question Usually answered in minutes!

Upper tension is too tight. Do not touch the balance wheel, thread take-up, needle, or other moving parts. Place the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right.

The Pattern Selection Dial may be turned in either direction. If the stitches get bunched together, lengthen the stitch length and continue sewing. However it downloaded in French. You do not want to void your warranty. Depending on the stitch selected, you may need to adjust the stitch width. Baste the cut design to the fabric in the location where desired.

Page page page A P Accesorios Place the second spool of thread onto the vertical spool pin as shown in fig. Page 29 Page 30 – Anchos y largos recomendados para cada p If it is, then it could be more serious and would need to see the doctor Machine Tech.

Brother XL User Guide – Page 1 of |

Lower the presser foot lever. Reverse sewing is used for back tacking and reinforcing seams. Turn the balance wheel toward you counter-clockwise to raise the needle holder to the highest position. Set the Stitch Width 2. Also See for XL Manual – 42 pages. Check the needle from the top and the sides. It’s probably because your upper tension is too loose. Remove the basting, if necessary. Free-arm sewing is convenient for sewing tubular and hard-toreach areas on a garment.

Manuual or electric shock may result. Do not lower the Presser Foot Brotherr while pushing in the area of the presser foot marked a in fig. Si las puntadas en ambos lados del ojal no parecen ser uniformes, se pueden hacer los siguientes ajustes. Good luck and I hope 6652 works out good for you.

If yes, Make sure your feed dogs are up Only use presser feet for this machine. If the plug fitted is not suitable for the power point in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. To check the needle, place the flat side of the needle on a flat surface.

Popular Tags needle bar feed dog tension bobbin tension assembly needle Levante el prensatelas con la palanca correspondiente. Please assign your manual to a product: I doubt that your problem is in the bobbin area.